iV-GO® is a purely mechanical system where the springs are used to generate the force needed to empty the content of IV-bag. It is a user-friendly device that is easy to use by the health professionals, with a simple loading and unloading mechanisms
Request material explaining all you need to know about the iV-GO®
Inspect drip chamber.
If the tubing is not connected to the patient inspect the end of tubing and ensure that IV-treatment is under way.
Legislation differs from country to country. In the Nordics health professional must operate (load & unload) the device.
Check to make sure there is no visible damage to iV-GO®. Let iV-GO® roll without the bag, push the roll back and load iV-GO®.
If no irregularities are noticed it is safe for use.
If irregularities are noticed, please contact support.
Make sure to close roller clamp and safely remove the needle out of patient.
Put iV-GO® with tubing away.
The flow can be adjusted by using roller clamp, please consult health professional on the appropriate flow for your treatment.
No. iV-GO® is purely mechanical, with no electronical built-in flow warning.
Flow rate is set by the available IV-equipment.
If alarm is necessary an external regulator can be connected to the IV-line
Normal cleaning can then take place by spraying and rinsing.
Do not subject the iV-GO® to autoclave.
Please consult manual for detailed instructions.
Under current legislation we advice to consult with health professional.
To start iV-GO® pull the release lever and open roller clamp.
To stop iV-GO® closer roller clamp.
Yes, please contact us for further information.
Yes, please contact us for further information
No, we advice to use IV-BACK®.
Contact us for further information.
No. IV-GO® is purely mechanical and contains no electronical systems.
Please make sure to inspect drip chamber and lid on iV-GO® to ensure that treatment is as intended.
IV-GO is designed to be used in various situations, eliminating the need for IV-pole.
Video instructions for use is currently in works and will be uploaded shortly.
At OSAA Innovation we have a lot of distributors located in the northern Europe.
Take a look at the map to find the one closest to you.
+45 31 84 23 98 (DK)
+45 22 52 09 15 (EN)
Address: Energivej 15, 1 th., DK-2750 Ballerup, Denmark
Fill the form with name and email, and we will contact you with the material, thank you!